Stag Mad Forum
Stag Mad Forum
Home | Profile | Register | Active Topics | Members | Search | FAQ
 All Forums
 Stag Mad Posts
 Triumph Stag Photos
 Stag Restoration

Note: You must be registered in order to post a reply.
To register, click here. Registration is FREE!

Screensize:
UserName:
Password:
Format Mode:
Format: BoldItalicizedUnderlineStrikethrough Align LeftCenteredAlign Right Horizontal Rule Insert HyperlinkInsert EmailInsert Image Insert CodeInsert QuoteInsert List
   
Message:

* HTML is OFF
* Forum Code is ON
Smilies
Smile [:)] Big Smile [:D] Cool [8D] Blush [:I]
Tongue [:P] Evil [):] Wink [;)] Clown [:o)]
Black Eye [B)] Eight Ball [8] Frown [:(] Shy [8)]
Shocked [:0] Angry [:(!] Dead [xx(] Sleepy [|)]
Kisses [:X] Approve [^] Disapprove [V] Question [?]

 
   

T O P I C    R E V I E W
lewy Posted - 28/08/2008 : 10:25:23
When I got the Stag it was going to be sent to the breakers yard.

It had been re-sprayed before, but was done badly (drips, runs, sprayed over all the rubber parts instead of removing them first.

I decided to re-spray the stag properly, and sort out any problems along the way.
At the moment I'm leaving the engine and mechanical side of things alone until the bodywork have been completed...

BODY WORK


Okay This is the stag when I got it before I stripped anything down:



The interior when I got it:



the back seat was wet through - rain had obviously got to it




The carpets were also wet... and growing mushrooms



The Rover V8 engine and ran but not smoothly - hopefully new plugs, oil and timing chain will sort this



Not many miles on the clock:



The rubber seal on the boot had corroded in places and let in water the first thing I did was drain the water out and check what rust the was to sort out:






Striping starts - all the bumpers chrome work, grill, lights etc removed:



The door cards are removed and boxed up - seats and carpets start to get removed:




nice colour of hammerite under the carpets





- so far I've found three different colours of paint on the Stag - original looking to be French blue, hammerite on insides probably to stop the rust, and a re-spray in pimento red


More to come!!!


5   L A T E S T    R E P L I E S    (Newest First)
lewy Posted - 24/06/2009 : 16:28:56
What a nightmare I'm having - Finding one bodge after another I've decided to strip things down completely. There's rust all over the place and most is caused by bad bodywork.

Here's some photos of where I'm up to:

A nasty bodge - no welding here - just a thin panel and filler - covered on the engine bay side with heat shield sponge...



A closeup of the filler mess:



When taking the heating system out there's lots of rust (again nicely hidden by the sponge). The sponge looks like it's been added to hide the bodge but in the long run has soaked up water and cause more problems.




and another close up:



Looks like there's lots more welding and bodypannels to get hold of

The joys of motoring eh?

Maybe next summer I'll be on the road


Lewy

The Stag Mad Team
lewy Posted - 06/01/2009 : 12:42:23
Here you go Peter A quick update -

I've been scraping and wire brushing - The sound deadening pads had to be removed (I know they cost quite a bit) There was water underneath and had started to rust. only surface but better to get it off now then wait until it becomes a hole. Heat gun and an old blunt chisel to get these off.



The brown paper and tape is just to stop the dust getting all over the dash - They are restoring an old transit van in the workshop and there is filler dust everywhere even with the extractors on, and since I've took the hood off I didn't want it to go on the dash etc

Lovely Multi Coloured interior

The previous owner had screwed the carpet to the floor, yes Screws These had started to rust as they were 2 inch long wood screws and hung out from underneath (what were they thinking?)

Still got a little more to do - then welding and preparing next

Lewy

The Stag Mad Team
lewy Posted - 02/01/2009 : 09:59:39
That's the problem - They always look good until you strip things back and find the rust. To be honest though for the year mine isn't too bad getting the welding sorted over the next few weekends.

Lewy

The Stag Mad Team
Mr. Twosheds Posted - 27/12/2008 : 18:05:53
Look forward to a progress report soon... The car looks good in the picture when you first got it. Hope you dont hit any unseen snags.

Triumph 1360 converible, Ducati 750 Monster, 2008 Jag (company car) Smells nice and thats all I can say about it.
lewy Posted - 09/10/2008 : 10:02:58
Time for an update I think.

Been working away at stripping everything, Took the carpet out and found lots of rust... in the process of getting this sorted out - Main problem areas are the rear seat pan, and the boot where it was filled with water. also lots of surface rust to sort in the passenger footwell.

Currently in the process of stripping the sound deadening pads in the front as water has gotten underneath.
Here's some pics:

Rear seat pan (a few holes :()











Passenger footwell under drivers seat:







Boot lid roof base (both sides are like this) bad filler and more rust




The dash that needs the vinyl sorting
Re-trimming in leather when I can afford it (long way off yet):







Will keep you all updated as I go along.

Booking a few days off work in the next couple of weeks hopefully to get some major work done on her.

Watch this space

Lewy


Lewy

The Stag Mad Team

Stag Mad Forum © 2000-2002 Snitz Communications Go To Top Of Page
Snitz Forums 2000